P0301 on a Jeep: Causes, Fixes & Repair Cost
๐ Moderate severity ยท drivable
If the check engine light is flashing, stop driving โ a severe misfire can damage the catalytic converter. A steady light is usually safe for a short drive to a shop.
What P0301 means on a Jeep
On a Jeep, P0301 means the engine computer has detected that cylinder 1 is not firing properly and is failing to contribute its share of power. Because the code names one cylinder, the fault is usually specific to cylinder 1, such as its spark plug, ignition coil, or fuel injector.
Is P0301 common on Jeeps?
P0301 is common on Jeeps with the 3.6L Pentastar V6, like the Wrangler and Grand Cherokee, where ignition coils and spark plugs are frequent wear items at higher mileage. The 2.0L turbo and 3.0L EcoDiesel in newer models can also misfire from coil or injector issues. Swapping the coil with another cylinder is a fast way to confirm the culprit.
Commonly reported on: Wrangler, Grand Cherokee, Cherokee, Gladiator.
Symptoms
- Check engine light on (flashing if severe)
- Rough idle or shaking at a stop
- Loss of power or hesitation under acceleration
- Poor fuel economy
Common causes
- most common: Worn or fouled spark plug in cylinder 1
- common: Failing ignition coil for cylinder 1
- common: Clogged or leaking fuel injector in cylinder 1
- less common: Vacuum leak near the intake
- less common: Low compression in cylinder 1 from engine wear
How to fix it
| Fix | DIY? | Typical cost |
|---|---|---|
| Replace the spark plug in cylinder 1 | Yes | $30โ150 |
| Replace the ignition coil for cylinder 1 | Yes | $80โ300 |
| Clean or replace the fuel injector in cylinder 1 | Mechanic | $150โ600 |
| Run a compression test to rule out internal engine wear | Mechanic | $100โ200 |
Frequently asked questions
Other common Jeep codes
P0301 on other brands
Looking for the full (non-brand-specific) guide? See the P0301 code page โ
Browse all Jeep codes: Jeep hub โ
Updated 2026-08. This page is informational and not a substitute for professional diagnosis.