P1295 Code: No 5 Volts to Throttle Position Sensor

🟠 Moderate severity · drivable

The car may run poorly, hesitate, or go into reduced power mode, so get it diagnosed soon.

What P1295 means

The throttle position sensor (TPS) needs a steady 5-volt reference signal to work. P1295 means the engine computer isn't sending that 5 volts, usually because of a wiring problem or a bad sensor. Without the TPS reading, the computer can't tell how far you've pressed the gas pedal. This code is most often seen on Chrysler, Dodge, and Jeep vehicles.

Symptoms

Common causes

How to fix it

FixDIY?Typical cost
Inspect and repair the TPS wiring and connectorYes$20–100
Test and replace the throttle position sensor if it is faultyYes$50–150
If wiring and sensor check out, have the PCM testedMechanic$150–400

Frequently asked questions

Can I drive with a P1295 code?
Usually yes, but the car may hesitate, idle rough, or lose power. Keep trips short and get it diagnosed soon.
What does 'no 5 volts to the TPS' mean?
The throttle position sensor has a 5-volt reference wire that powers it. The code means that voltage is missing, which is usually a wiring or connector problem rather than a bad sensor.
Where is the throttle position sensor?
It's mounted on the throttle body, where the intake air enters the engine, and it's tied to the throttle shaft that moves when you press the gas pedal.

Related codes

P0121
P0121 Code: Throttle Position Sensor/Switch Circuit Range/Performance
P0122
P0122 Code: Throttle Position Sensor/Switch Circuit Low Input
P0123
P0123 Code: Throttle Position Sensor/Switch Circuit High Input

Updated 2026-08. This page is informational and not a substitute for professional diagnosis.