P0135 on a Jeep: Causes, Fixes & Repair Cost
🟠 Moderate severity · drivable
Safe to drive, but the sensor warms up slowly and fuel economy and emissions may suffer until the heater circuit is fixed.
What P0135 means on a Jeep
On a Jeep, P0135 means the heater inside the bank 1 upstream oxygen sensor isn't working. The sensor sits in the exhaust before the catalytic converter and uses its heater to reach working temperature quickly. With a dead heater, the sensor reads slowly and the engine may run rich while warming up.
Is P0135 common on Jeeps?
P0135 is common on higher-mileage Jeeps like the Wrangler, Cherokee, and Grand Cherokee. The heater element inside the sensor fails most often, and wiring can suffer from heat and off-road abuse. On Wranglers the sensor is easy to reach, making it a popular DIY fix.
Commonly reported on: Wrangler, Cherokee, Grand Cherokee, Compass.
Symptoms
- Check engine light is on
- Slower sensor warm-up after cold start
- Slightly worse fuel economy
- Possible failed emissions test
Common causes
- most common: Failed O2 sensor heater element
- common: Damaged or corroded wiring or connector
- common: Blown heater circuit fuse or relay
- less common: Defective aftermarket sensor
How to fix it
| Fix | DIY? | Typical cost |
|---|---|---|
| Replace the upstream oxygen sensor | Yes | $80–210 |
| Repair the wiring or connector | Mechanic | $80–200 |
| Replace the blown fuse or relay | Yes | $10–40 |
Frequently asked questions
Other common Jeep codes
P0135 on other brands
Looking for the full (non-brand-specific) guide? See the P0135 code page →
Browse all Jeep codes: Jeep hub →
Updated 2026-08. This page is informational and not a substitute for professional diagnosis.