P0467 Code: EVAP Purge Flow Sensor Circuit Low
🟢 Low severity · drivable
Safe to drive — it's an emissions-sensor circuit fault and won't affect how the car runs.
What P0467 means
The purge flow sensor is sending a signal that reads lower than it should, often near zero. This usually means a faulty sensor, a short to ground, or damaged wiring.
Symptoms
- Check engine light is on
- Possible faint fuel smell
- Usually no driving symptoms
Common causes
- most common: Faulty purge flow sensor
- common: Short to ground or damaged wiring
- common: Loose connector
How to fix it
| Fix | DIY? | Typical cost |
|---|---|---|
| Inspect the wiring and connector and repair any damage | Yes | $20–100 |
| Replace the purge flow sensor | Yes | $40–150 |
Frequently asked questions
Can I drive with a P0467 code?
Yes. It's an emissions-sensor circuit fault and shouldn't affect how the car drives.
What does P0467 mean?
The purge flow sensor signal is reading too low, which usually points to a bad sensor, a short to ground, or damaged wiring.
How much does it cost to fix P0467?
$40–150 for a new purge flow sensor, or $20–100 for wiring repairs plus labor.
Related codes
P0465
P0465 Code: EVAP Purge Flow Sensor Circuit
P0466P0466 Code: EVAP Purge Flow Sensor Circuit Range/Performance
P0468P0468 Code: EVAP Purge Flow Sensor Circuit High
Related guide: How to Reset a Check Engine Light →
Updated 2026-08. This page is informational and not a substitute for professional diagnosis.