P0463 on a Toyota: Causes, Fixes & Repair Cost
🟢 Low severity · drivable
Safe to drive, but the fuel gauge may be wrong — track your miles or fill up often so you don't run out of gas.
What P0463 means on a Toyota
On a Toyota, P0463 means the fuel level sender inside the tank is sending voltage that's too high, so the computer thinks the tank is full. The sender is built into the fuel pump module on most Toyotas, and its resistor strip wears with age and mileage. The engine runs normally — the usual result is just a fuel gauge stuck on full.
Is P0463 common on Toyotas?
P0463 is common on higher-mileage Toyotas like the Camry, Corolla, and RAV4. The sender's resistor strip wears down over time, and on these models replacing it means accessing the fuel pump module, usually through the rear seat or under the car. A gauge stuck on full is the typical symptom, not a drivability problem.
Commonly reported on: Camry, Corolla, RAV4.
Symptoms
- Check engine light on
- Fuel gauge stuck on full
- Fuel gauge may drop suddenly or read wrong
- No change in how the car drives
Common causes
- most common: Worn fuel level sender inside the fuel pump module
- common: Short or damaged wiring in the fuel level circuit
- common: Corroded connector on the fuel pump module
- less common: Faulty instrument cluster reading
How to fix it
| Fix | DIY? | Typical cost |
|---|---|---|
| Check the fuel level sensor wiring and connector | Yes | $0–40 |
| Replace the fuel pump module with sender | Mechanic | $250–550 |
| Repair a short or broken wire in the sensor circuit | Mechanic | $80–200 |
Frequently asked questions
Other common Toyota codes
P0463 on other brands
Looking for the full (non-brand-specific) guide? See the P0463 code page →
Browse all Toyota codes: Toyota hub →
Updated 2026-08. This page is informational and not a substitute for professional diagnosis.